







Ask a Question About This Product
This offer ends in:
SINK8060LEFT is a single-bowl commercial sink constructed from stainless steel with left-side bowl placement and 100mm rear splashback. Bowl dimensions measure 480mm wide × 450mm deep × 220mm high. Unit ships flat-packed and assembles on adjustable feet to 900mm working height.
Commercial Application
Single-bowl configuration supports dedicated wash stations in prep areas where utensil washing, vegetable cleaning, or hand-wash compliance is required. Left-bowl layout positions draining area to operator's right hand during washing cycles. 100mm splashback prevents water migration to wall surfaces during service hours.
600mm depth fits against standard kitchen wall runs without protruding into prep corridors. 1000mm width provides work surface beside bowl for sorted items or drying racks. Adjustable feet compensate for uneven floor surfaces common in older commercial buildings.
Key Operational Advantages
- Stainless steel throughout — no galvanised components in wet zones
- 480 × 450 × 220mm bowl handles commercial pot washing and bulked vegetable loads
- Pre-drilled faucet hole accepts standard commercial mixer taps
- Anti-runoff edge contains spillage during high-volume washing cycles
- Adjustable feet range compensates for 20–30mm floor variance
- 13kg assembled weight permits two-person installation without lifting equipment
Technical Specifications
| Specification | Details |
|---|---|
| Model / SKU | SINK8060LEFT |
| Certification | Meets commercial kitchen hygiene and safety standards applicable to CE (UK & EU), NSF (USA) and CSA (Canada) requirements. |
| Weight | 13.0 kg (28.7 lbs) |
Construction & Build Quality
All stainless steel fabrication with welded seams at bowl junctions. Bowl pressed from single sheet with corner radii for drainage. Splashback runs full width and folds 90° at base for water diversion. No undershelf fitted to maintain open leg access for cleaning inspections.
- Stainless steel grade suitable for continuous water contact and detergent exposure
- Adjustable feet threaded into leg assemblies with 20mm height adjustment range
- Pre-drilled tap hole 35mm diameter accepts commercial mixer cartridges
- Anti-runoff lip formed along front and side edges to contain splashing
Suitable Operations
- Commercial kitchens
- Hotel prep areas
- Restaurant kitchens
- Catering production facilities
- Food processing operations
Procurement & Support
TurcoBazaar supplies Zodex commercial sinks from UK distribution to buyers in UK, Europe, USA, Canada, Middle East, and Africa. Unit ships flat-packed in 450 × 480 × 220mm carton at 13kg. Freight consolidation available for multi-unit orders or container shipments to hotel refits and chain rollouts.
Frequently Asked Questions
Q: What steel grade is used in SINK8060LEFT construction?
A: Unit fabricated from food-grade stainless steel suitable for commercial kitchen wet zones. Material resists corrosion from detergents and chlorinated water supplies. No galvanised or mild steel components in contact areas.
Q: What load capacity does the work surface support?
A: Flat surface beside bowl rated for 30kg distributed load — sufficient for stacked drying racks or bagged produce. Concentrated point loads above 15kg require distribution plates. Adjustable feet must contact solid flooring for rated capacity.
Q: Can I add an undershelf after installation?
A: Factory design omits undershelf to permit floor cleaning access during hygiene audits. Aftermarket shelves must not obstruct leg access or trap debris beneath unit. Zodex does not supply retrofit shelf kits for this model.
Q: Is the splashback height compliant with health codes?
A: 100mm splashback meets UK, EU, and North American commercial kitchen standards for wall protection at wash stations. Some jurisdictions require sealed joint between splashback and wall — verify local code before installation.
Q: Can the sink be ordered with right-side bowl placement?
A: SINK8060LEFT denotes left-bowl configuration. Right-bowl variant available under separate model code. Bowl position cannot be reversed during assembly due to pre-drilled plumbing connections and drainage slope.